Step 1: select “Install CentOS 6 with Eucalyptus Cloud-in-a-box”, when the boot screen loads.
Step 2: You may be asked to check the media, to ensure that there are no data issues.You will then also asked for language, type of keyboard and installation method.
Step 3: In the next step you will be asked to give network information.Here, enter IP address, Netmask, Default Gateway, and a comma-delimited list of DNS servers.Also select mode(static/dynamic) and network interface.
Step 4: In the next step you will be asked to select the nearest time zone and root password for the system.
Step 5: In this step, you will be asked for cloud configuration option.Here you must have enter range of public IP address.The new virtual instance created by Eucalyptus will receive IP addresses from this range.
Step 6: You will be asked disk install options in this step. Eucalyptus is intended to be the primary application on the system; by default, it will take up all disk space on the system.Linux admin can set up the separate partition for Eucalyptus here.After these steps, Eucalyptus installation will begin.